Hydration Bar for Modular Nests

This Hydration Bar forms part of our large modular nest system.

It can be attached to any side of a modular nest (except a side with entrances) and can have either natural sponge or plaster as the moisture source. This sponge or plaster can be removed/replaced at any point if needed. To add water, simply remove the small blocks containing magnets holding the acrylic down, remove the acrylic and add water.

This hydration bar is attached to the nest using powerful magnets. To make the setup stronger, we have developed 'connector bars'. Two are needed to connect the hydration bar to the nest. To connect to the nest, simply insert two connector bars into the hydration bar and insert the other end of these connector bars into the nest.

If you are not going to be attaching a nest to the other side of the hydration bar, you will need to select a 'Hydration Bar Blocking Plate' when ordering to block the entrance and to stop the humidity from escaping.

If you are going to be attaching a modular nest to the other side, you will need to select two additional 'connector bars' when ordering.

This hydration bar also allows the nests to be stacked if required. A separate 'stacking set' is required.

What's Included

1x Hydration Bar with Sponge or Plaster

2x Connector Bars OR 1x Hydration Blanking Plate

Plaster or Songe moisture sources

What's NOT included but might be needed

Modular Stacking Set

Modular Stacking Set with Nest